Inrush Current Limiter; Logo! Icl230 - Siemens SITOP Series Equipment Manual

3.3

Inrush current limiter

3.3.1

Logo! ICL230

The device can be mounted in a control cabinet and snapped onto standard mounting rails
(see Chapter Mechanical system (Page 93)), or can be mounted on walls and panels using the
withdrawable mounting lug (see Figure 3-7 Wall/panel mounting (Page 52)).
Mounting
To mount the device, position it with the mounting rail guide at the upper edge of the
standard mounting rail and press down to lock it into place. If this is too difficult, press the
slider ④ at the same time, as described under "Removal".
Removing
To remove, pull up the slider ④ using a screwdriver (see Figure 3-6 Mounting/removal
(Page 51)) and disengage the device at the bottom edge of the standard mounting rail. Then
you can remove the device from the upper edge of the standard mounting rail.
Figure 3-6
SITOP expansion modules
Equipment Manual, 09.2022, A5E36605235-2-76
Mounting/removal
Mounting/removal
3.3 Inrush current limiter
51