Table of Contents
Advertisement
TeamPoS 3000 XT
3. Remove the back cover by pushing in on the
latch at the bottom and long edge, then lift off
the back cover.
4. Remove the tape holding the cable connector.
Ease the connector cable out of the side of the
LCD. Connect the plug to the MSR board.
5. Slide the board into the grooves in the top of
the chassis. Be sure the cable is not pinched
between the MSR and LCD. Secure with two
screws.
D900000172
Installation and Maintenance Manual
Mounting
edge latch
Bottom
edge latches
Connect plug
to MSR board
Secure with
two screws
5-3
Advertisement
Table of Contents
