Replacing The Optical Drive; Procedure; Post-Requisites - Dell D19M Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
•

Procedure

•

Post-requisites

Procedure
1. Align and snap the optical-drive bezel to the optical drive.
2. Align the screw holes on the optical-drive bracket with the screw holes on the optical drive.
3. Replace the three screws (M2xL2) that secure the optical-drive bracket to the optical drive.
4. Slide the optical-drive assembly into the optical-drive bay through the front of the computer.
5. Align the screw hole on the optical-drive assembly with the screw hole on the chassis.
6. Replace the screw (#6-32xL3.6) that secures the optical-drive assembly to the chassis.
7. Lift and rotate the side-chassis away from the computer.
8. Connect the data cable and power cable to the optical drive.
9. Rotate the side-chassis towards the computer until it snaps into place.
10. Place the computer in an upright position.
Post-requisites
Replace the computer cover.

Replacing the optical drive

computer. After working inside your computer, follow the instructions in
Replacing the optical drive
21
After
35