Specifications; Attachments/Accessories; Operation; Before Operating - Toro Groundsmaster 4010-D Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Width of cut
overall
front cutting unit
side cutting unit
front and one side cutting unit
Overall width
cutting units down
cutting units up (transports)
Overall length
Height
Height with ROPS
Height with cab
Ground clearance
Wheel tread (to center of tire)
front
rear
Wheel base
(Net Weight )
(Net Weight with cab)

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
335 cm (132 inches)

Before Operating

157 cm (62 inches)
107 cm (42 inches)
246 cm (97 inches)
If you leave the key in the ignition switch, someone
could accidently start the engine and seriously
injure you or other bystanders.
345 cm (136 inches)
183 cm (72 inches)
Remove the key from the ignition before you do any
maintenance.
342 cm (135 inches)
140 cm (55 inches)
Checking the Engine Oil
217 cm (85.3 inches)
237 cm (93.3 inches)
Service Interval: Before each use or daily
17 cm (6-1/2 inches)
The engine is shipped with oil in the crankcase; however, the
oil level must be checked before and after the engine is first
started.
114 cm (45 inches)
The crankcase capacity is 5.7 liters (6 qt.) with the filter.
119 cm (47 inches)
Use high-quality engine oil that meets the following
141 cm (55-1/2
specifications:
inches)
•
1856 kg (4091 lbs.)
2107 kg (4645 lbs.)
•
•
Toro Premium Engine Oil is available from your distributor
in either 15W-40 or 10W-30 viscosity. See the parts catalog
for part numbers.
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If it has
already been run, allow the oil to drain back down to the
sump for at least 10 minutes before checking. If the oil level
is at or below the "add" mark on the dipstick, add oil to bring
the oil level to the "full" mark. DO NOT OVERFILL.
If the oil level is between the "full" and "add" marks, no
additional oil is required.
23
CAUTION
API Classification Level Required: CH-4, CI-4 or higher.
Preferred oil: SAE 15W-40 (above 0°F)
Alternate oil: SAE 10W-30 or 5W-30 (all temperatures)
1. Park the machine on a level surface. Unlock the engine
cover latches.
2. Open the engine cover.
3. Remove the dipstick, wipe it clean, install the dipstick
into the tube, and pull it out again. The oil level should
be up to the Full mark (Figure 10).