Related Manuals for Toro PowerPlex 51132
Summary of Contents for Toro PowerPlex 51132
- Page 1 Form No. 3418-117 Rev B PowerPlex ™ 36cm 40V MAX String Trimmer Model No. 51132—Serial No. 318000001 and Up Model No. 51132T—Serial No. 318000001 and Up *3418-117* B Register at www.Toro.com. Original Instructions (EN)
- Page 2 (corded) power tool or battery-operated (cordless) power tool. You may contact Toro directly at www.Toro.com for product and accessory information, help finding a Work area safety dealer, complete warranty details, or to register your Keep the work area clean and well lit.
- Page 3 Store idle appliances indoors. When not Use only the following type and size in use, appliances should be stored indoors battery(ies): Toro battery Model 88525 or in a dry and high or locked-up place, out of 88526. the reach of children.
-
Page 4: Sound Pressure
Sound Pressure This unit has a sound pressure level at the operator’s ear of 77.6 dBA, with an Uncertainty Value (K) of 3 dBA. The sound pressure level was determined according to the procedures outlined in EN ISO 11201. Sound Power This unit has a guaranteed sound power level of 96 dBA, which includes an Uncertainty Value (K) of 1 dBA. -
Page 5: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal136-2491 136-2491 1. Do not discard. 2. Double insulated decal136-2492 136-2492 decal136-2501... - Page 6 decal136-2534 136-2534 1. The battery does not 4. Stop—follow these decal136-2537 136-2537 come out of the box fully instructions before first charged. use. 1. Warning—read the Operator’s Manual; wear hearing 2. Place the battery in the 5. Read the Operator’s protection;...
- Page 7 Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Mount the battery charger. Connector knob Unfold the handle. Auxiliary handle Install the auxiliary handle. Guard Mounting the guard to the base of the trimmer.
-
Page 8: Unfolding The Handle
Unfolding the Handle Parts needed for this procedure: Connector knob Procedure Unfold the handle (A of Figure Install the connector knob and nut to secure the handle (B of Figure Note: The nut that holds the handle connector knob in place is lightly secured in the connector housing with the piece of tape. -
Page 9: Installing The Auxiliary Handle
Installing the Auxiliary Installing the Guard Handle Parts needed for this procedure: Guard Parts needed for this procedure: Phillips head screw Auxiliary handle Procedure Procedure Remove the 4 Phillips head screws that are taped to Line up the groove along the handle with the the guard and use them to install the guard (Figure groove on the auxiliary handle and slide the... -
Page 10: Product Overview
Product Overview Operation Specifications Starting the Trimmer Make sure that the vents on the trimmer are Weights clear of any dust and debris. Mass of the machine without 3.2 kg (7.0 lb) the battery Mass of the machine with 4.2 kg (9.2 lb) battery 88525 Mass of the machine with 4.8 kg (10.5 lb) -
Page 11: Charging The Battery Pack
Shutting Off the Trimmer To shut off the trimmer, release the trigger. Whenever you are not using the trimmer or are transporting the trimmer to or from the work area, remove the battery pack. Removing the Battery Pack from the Trimmer Press the battery latch on the machine to release the battery pack and slide the battery pack out of the g228487... -
Page 12: Adjusting The Auxiliary Handle
Adjusting the Auxiliary Refer to the following table to interpret the LED indicators on the battery charger. Handle Left Light Right Light Indicates: Release the auxiliary-handle latch (A of Figure Charger is on; no battery 12). pack inserted Slide the auxiliary handle up or down to your Battery pack is charging desired height (B of Figure... -
Page 13: Operating Tips
Operating Tips • Keep the trimmer tilted toward the area being cut; this is the best cutting area. • The string trimmer cuts when you move it from left to right. This prevents the trimmer from throwing debris at you. •... -
Page 14: Maintenance
Use only 2 mm (0.08 inch) diameter monofilament After each use of the trimmer, complete the following: string. Use original manufacturer’s replacement string for best performance (Toro Part No. 88546TE). Remove the battery from the trimmer. Wipe the trimmer clean with a damp cloth. Do... -
Page 15: Replacing The String
For more information on recycling lithium-ion battery packs and to locate the battery recycling facility closest to you, visit www.Call2Recycle.org (US and Canada only). If you are located outside of the US and Canada, please contact your authorized Toro distributor. -
Page 16: Troubleshooting
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The tool does not start. - Page 17 Problem Possible Cause Corrective Action An audible tone sounds when advancing 1. This is a normal occurrence. 1. Stop the tool by releasing the trigger the line using the bump feed. and then start the tool. It is difficult to remove the battery pack 1.
- Page 18 Notes:...
- Page 19 Notes:...
- Page 20 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.