Related Manuals for Toro 51136
Summary of Contents for Toro 51136
- Page 1 Form No. 3408-800 Rev B Power Plex™ 61cm 40V MAX Hedge Trimmer Model No. 51136—Serial No. 317000001 and Up Model No. 51136T—Serial No. 317000001 and Up *3408-800* B Register at www.Toro.com. Original Instructions (EN)
- Page 2 It is designed to use only battery pack Models Failure to follow all warnings and instructions 88525 (provided with Model 51136) or 88526. may result in electric shock, fire and/or Read this information carefully to learn how to operate serious injury.
- Page 3 D. Remove any adjusting key or wrench G. Use the power tool, accessories and before turning on the power tool. A tool bits etc. in accordance with these wrench or a key left attached to a rotating instructions, taking into account the part of the power tool may result in personal working conditions and the work to injury.
- Page 4 • Additional Safety Warnings for the Charger Hold the power tool by insulated gripping surfaces only, because the cutter blade may • This charger can be used by persons with reduced contact hidden wiring or its own cord. Cutter physical, sensory or mental capabilities or lack of blades contacting a “live”...
-
Page 5: Sound Pressure
Sound Pressure the leakage gets in your eyes, flush your eyes with clean water for a minimum of 10 minutes and seek immediate medical attention. This unit has a sound pressure level at the operator’s ear of 82.3 dBA, with an Uncertainty Value (K) of 3 •... -
Page 6: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. Symbol Designation/Explanation Read the instruction manual. Wear hearing protection. decal136-2496 136-2496 Wear eye protection. - Page 7 decal136-2504 136-2504 1. The battery pack is 3. The battery pack is too charging. warm. 2. The battery pack is fully 4. The battery pack needs to be replaced. charged. decal136-2537 136-2537 1. Warning—read the Operator’s Manual; wear hearing protection; wear eye protection; do not operate in wet conditions.
-
Page 8: Product Overview
3000 dual action spm at 40V maximum No-load Speed Cutting width 18 mm Charger Type 88527 Battery Type 88525 (included with 51136), 88526 (sold separately) Weights Mass of the machine without 3.6 kg (8.0 lb) the battery Mass of the machine with 4.6 kg (10.2 lb) -
Page 9: Operation
Operation The trimmer stays on as long as the auxiliary-handle switch is engaged and the trigger is squeezed. The lock switch may be Starting the Hedge Trimmer released once the hedge trimmer is running (Figure 1. Remove the protective cover from the cutter blades (Figure Rotating the Hedge Trimmer... -
Page 10: Removing The Battery Pack
Removing the Battery Pack Press the battery latch on the tool to release the battery pack and slide the battery pack out of the tool (Figure g192748 Figure 7 1. Battery pack cavity 4. Battery-charge-indicator g194190 button Figure 6 2. Battery pack terminals 5. -
Page 11: Operating Tips
Green Battery pack is charged Orange Battery pack is too warm Red Blinking Replace the battery pack Operating Tips • Use the power tool for cutting in either direction in a slow, sweeping action from side to side. • Stand so that you are stable and balanced on both feet. -
Page 12: Maintenance
Maintenance • To reduce the risk of serious personal injury, do not store the battery pack outside or in vehicles. • Store the tool, battery pack, and battery charger Disconnect the product from the power supply (i.e. in an enclosed clean, dry area. remove the plug from the power supply or the battery pack) before maintenance or cleaning work. -
Page 13: Troubleshooting
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The tool does not start. - Page 14 Problem Possible Cause Corrective Action 1 LED indicator is blinking on the battery 1. The battery pack voltage is low. 1. Place the battery pack on the charger. pack. It is difficult to remove the battery pack 1. The battery pack/tool is new or there 1.
- Page 15 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
- Page 16 – Failure to follow proper maintenance procedures or recommended The Toro GTS Starting Guarantee does not apply when the product is used commercially. fuel procedure Some engines used on Toro Products are warranted by the engine manufacturer.