Using The Imagepress Server; Starting, Shutting Down, Rebooting, And Restarting The Imagepress Server - Canon imagePRESS Server G250 V2 Service Manual

Using the imagePRESS Server

This chapter describes how to use the imagePRESS Server.
Starting, shutting down, rebooting, and restarting the imagePRESS
Server
Always use the following procedures to start, shut down, reboot, or restart the imagePRESS Server.
IMPORTANT:
Always verify that the imagePRESS Server is not in use before you power off or restart it. Make sure that the system is not
processing or printing a job. Before you take the imagePRESS Server off the network, always obtain permission from the
network administrator.
■ To start the imagePRESS Server
1. Press the power switch to set ON (|).
2. Power on the printer using the main power switch.
The imagePRESS Server will automatically turns on as the printer warms up.
If it has been enabled in Setup, the imagePRESS Server Start page will also print automatically when the imagePRESS
Server is ready for use.
NOTE:
If the imagePRESS Server does not start up within 15 minutes, see the Startup section of
when printer does not print" on page
■ To shut down the imagePRESS Server
1. Make sure that the imagePRESS Server is not receiving, processing, or printing any jobs.
2. Make sure that the printer is not in use.
3. Power off the printer using the main power switch on the front.
The imagePRESS Server will automatically start the shutdown process. Wait for the printer and the imagePRESS Server to
power off completely.
4. Move the imagePRESS Server power switch to the OFF (O) position.
Figure 2: Starting the imagePRESS Server
77.
11
2. Using the imagePRESS Server
"Table: Table 1: Causes and solutions