Polaris RZR XP 1000 Owner's Manual page 140

MAINTENANCE
SPARK ARRESTOR
• Never operate the vehicle without the spark arrestor.
• Remove any combustible materials from the area.
Failure to heed the following warnings while servicing the spark arrestor
• Never run the engine in an enclosed area. Exhaust contains poisonous
carbon monoxide gas that can cause loss of consciousness or death in a
very short time.
• Do NOT perform service on the spark arrestor while the system is HOT.
Exhaust system temperatures can reach extreme temperatures. Allow
components to cool sufficiently before proceeding.
• Do not stand behind or in front of the vehicle while purging the exhaust
system.
• Never go under the vehicle while it is inclined.
• Wear eye protection and gloves while servicing.
Periodically clean the spark arrestor
to remove accumulated carbon. A
plugged spark arrestor will affect
engine performance. Clean daily
when driving in mud and water.
Replace a cracked or damaged
arrestor before operating.
1. Remove the arrestor nut
2. Remove the arrestor from the end of the muffler.
3. Use a non-synthetic brush to clean the arrestor screen
may melt if components are warm. If necessary, blow debris from the screen
with compressed air.
4. Inspect the screen for wear and damage. Replace a worn or damaged
screen.
5. Reinstall the arrestor. Torque bolt to 7.4 ft. lbs. (10 N⋅m).
138
could result in serious injury or death.
q
and retaining bolt
WARNING
w
.
e
. A synthetic brush