Audio Output Jack; Power Indicator; 24 Vac/12 Vdc Power Terminals; Network Socket - Sanyo VCC-HD2500P Manual

Connect this jack via an audio cable to the audio input jack of an amplified speaker system or the monitor.
This indicator lights up when the camera is powered on.
When the camera is on, this indicator blinks to indicate the following camera statuses:
Recording to SD memory card stopped
Firmware update in progress
An SD memory card error occurred (Fast blink)
Use these terminals to connect a 24 VAC or 12 VDC power supply. The power indicator lights up when the camera
is powered on.
For details, refer to the "Basic Connections" section.
Use this jack to connect an optional external microphone to listen to the sound while monitoring the surveillance
video, or simultaneously record the video and sound.
This jack supports 3.5-mm diameter monaural microphone plugs, or monaural line-level input plugs (the
left channel only for stereo plugs).
Use this socket to connect the camera to your PC to enable network operation.
For details, refer to the "Basic Connections" section.
Right: Link access indicator (Green)
This indicator lights up approx. 3 seconds after power on, if a connection has been established
between the camera and the network.
After that, it will blink when data are being transmitted via the network.
Left: Speed indicator (Orange)
The camera automatically detects the local network transmission speed (10BASE-T or 100BASE-
TX).
This indicator lights up when 100BASE-TX data transmission is in progress; it goes out when
10BASE-T data transmission is in progress.
For the detailed connection procedure, refer to the "Alarm Input/Output Terminal Connections" section.
Alarm input or Day/Night switching terminals (ALARM IN1/2)
1
These input terminals can be used for either of the following purposes:
Alarm input
Connecting an external switch, infrared sensor, or other device to these terminals enables the camera to
detect alarm conditions such as the entry of an intruder.
Day/Night switching
Normally, switching the camera between the color and black-and-white video modes is automatically
accomplished by the Day/Night function.
Introduction 6/18