Setting
Background
The selected background screen will be displayed when no
input signal is detected.
Blue . . . Blue colored background.
User . . . The image you captured.
Black. . . Black colored background.
Lamp mode
This projector is equipped with 2 projection lamps and the
number of using lamps can be switched to 2 lamps or 1 lamp.
Using 1 lamp maintains the life of projection lamps.
Press the SELECT button at Lamp mode to display a dialog
box. Use the Point ed buttons to select "2-Lamps", "Lamp1" or
"Lamp2" and press the SELECT button. Then the confirmation
message appears. Select [Yes] and press the SELECT button.
2-Lamps . . Two lamps turn on.
Lamp1 . . . Only Lamp1 turns on.
Lamp2 . . . Only Lamp2 turns on.
Lamp control
Lamp control
This function allows you to change brightness of the screen.
Normal . . . Normal brightness.
Eco 1. . . . . Lower brightness and Fan speed decrease.
Eco 2. . . . . Lower brightness and Fan speed increase.
Lamp life control
Select the lamp operation when the total lighting time of a
lamp exceeds the recommended total hours of use.
Mode 1 . . . A lamp can be turned on even after exceeding
the recommended total hours of use.
Mode 2 . . . A lamp is not turned on after exceeding the
recommended total hours of use.
Lamp interval
This function can be used to automatically switch the lamp
that is turned on after a certain period of time in order to
reduce the lamp deterioration when 'Lamp1' or 'Lamp2' has
been selected in 'Lamp mode' setting.
Use the Point
buttons to select from (Off/Auto/24H/
7 8
200H/500H/1000H/2000H).
50
Lower brightness reduces the lamp power
consumption and extends the lamp life.
Lower brightness reduces the lamp power
consumption and extends the lamp life. It is
recommended to use Eco 2 when using the
projector continuously over a long period of
time.
✔
Note:
•"User" cannot be selected when the image is not
captured.
✔
Note:
• When switching from one of lamps to the other
(e.g. when switching from Lamp1 to Lamp2), both
lamps will light until the brightness of the lamps
are stabilized.
• When neither of the two lamps is lighted, the
projector will shutdown automatically.
• When either of the two lamps does not light up,
the LAMP 1/2 REPLACE indicator blinks orange
and the projector will light the other automatically.
(X mark will appear on the unlighted lamp in the
Lamp Status Display. See page 65 for details.)
✔
Note:
• The fan noise becomes louder in Eco 2 than in
Eco 1. Select the suitable mode for the used
environment.
✔
Note:
• If Mode 2 has been selected and either of two
lamps exceeded its recommended total hours
of use, Lamp interval mode will be fixed to 'Off'.
Also, '2-Lamps' icon in the Lamp mode and the
icon of lamp which exceeded its recommended
total hours of use will be displayed in grayout.
• If Mode 2 has been selected and both lamps
exceeded the recommended total hours of use,
the warning icon will be displayed at the time of
power-on. Then the projector will turn off after 3
minutes.
✔
Note:
• When either of the two lamps is out, the projector
will light the other automatically even if 'Off' is
selected.
• When 'AUTO' is selected, the projector
automatically detects which lamp is used less
often than the other at the time of power-on and
lights it.
• The setting values of time interval may not be
accurate, and should be used only as a guide.