Remote Control Code - Sanyo PDG-DET100L Owner's Manual

7500 ansi, sxga+, dlp

Hide thumbs Also See for PDG-DET100L:

Table of Contents

Part Names and Functions

Remote Control Code

The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote

control codes prevents interference from other remote controls when several projectors or video equipment

next to each other are operated at the same time. Change the remote control code for the projector first before

changing that for the remote control. See "Remote control" in the Setting Menu on page 56.

Check the Reset Switch to "Use position" in the

compartment lid on the back of the remote control.

While holding down the MENU button, press

and release the IMAGE ADJ. button the number

of corresponding times you would like to set the

number of the remote control code for the projector.

Remote Control Code

Code 1

Code 2

Code 3

Code 4

Code 5

Code 6

Code 7

Code 8

Number of Times

Pressing IMAGE ADj .

button

Reset position

Use position

Reset switch

MENU button

IMAGE ADj .

button

Table of Contents