Customer Care Europe, Middle East & Africa
SCCE Training Group
Additional Information
BB shield removing instructions
For BB shield removing it is important to lay the PWB on level surface in away that the bottom connector does not
touch the underground to prevent bending of PWB and cracking of the connector's solderings (See pictures below).
Wrong
Correct
When removing the BB shield, be very careful because the Flash D450 could be damaged (see pictures on the next
page). Start by lifting and bending the lid with tweezers at the marked points 1- 3 (see pictures below).
Do not use too much force on the frame because it could be damaged and also the PWB could be mechanically stressed.
© NMP 2003
CONFIDENTIAL
NPE-4 6310/NPL-1 6310i
Date 22.04.2003
Checked by:
SCCE Training Group
7 (29)
Repair Hints
Version 3.0 Approved
Approved by:
SCCE