1. Connect the provided USB cable and VGA cable or DVI cable to the console drawer and the server. (See ①
in the figure above.)
2. Plug the power cord of the server to power outlet. (See ② in the figure above.)
Do not power on the server at this step.
3. Plug the power cord into the power connector of the console drawer.
4. Plug the power cord into the power outlet.(See ④)
5. Confirm connection, then turn on the power of the server.
6. After the server is started, set up and confirm the LCD, the keyboard, and the touchpad. If you change
settings, restart the server.
Express5800 Series 17.3-inch LCD Console Drawer (1port) User's Guide
Note
Do not connect both of VGA cable and DVI cable at the same time. Doing so may
cause malfunction.
Note
Do not use any pow er cord inappropriate for N8143-122F console drawer.
When you bend cables or the pow er cord, make sure that bending radius is
greater than or equal to 60mm. If bending radius is too small, it may break cables
or the pow er cord.
Tips
For how to configure the LCD, see page 73.
For how to configure the keyboard, see page 45.
For how to configure the touch pad, see page 47.
57