Page 1
Phone : (770) 282-8686 WASHLET Warranty Registration and Inquiry For product warranty registration, TOTO U.S.A. Inc. recommends On-Line Warranty Registration. Please visit our web site http://www.totousa.com. If you have questions regarding warranty policy or coverage, please contact TOTO U.S.A. Inc., Customer Service Department, 1155 Southern Road, Morrow, GA 30260 (888) 295 - 8134 or (678) 466 - 1300 when calling from outside of U.S.A.
As you sit As you stand up ....42 Limited Warranty Removing odors inside Deodorizer the bowl unit. A mist is automatically sprayed inside the bowl unit to make it Pre-mist more diffi cult for dirt to adhere. *1 Except SW3004...
The product is abnormally hot. The toilet seat cushion is out of place. Continued use after malfunction could cause a fi re, electric shock, heat, short circuit, injury or water damage. *1 Except SW3004...
Page 4
Safety Precautions (Continued) WARNING CAUTION This is an electrical product. Do not install it anywhere water is likely to get on Do not use the product if the main unit is unstable. the product or anywhere with humidity high enough that water is likely to form ...
Page 5
Safety Precautions (Continued) CAUTION DANGER To reduce the risk of electrocution: 1. Do not use while bathing. If a water leak should occur, always close the shutoff valve. 2. Do not place or store the product where it can fall or be pulled into a tub or sink. When the ambient temperature is likely to drop to 32 °F (0 °C) or lower, prevent damage to the pipes and hoses due to freezing.
Safety Precautions Operational Precautions (Continued) ■ For prevention of malfunctions ■ For prevention of damage Grounding Instructions ●Wipe plastic areas such as the main unit with a <About the seat switch> soft cloth tightly wrung out with water. ●When you sit on the toilet seat, the seat switch This product should be grounded.
Control panel Heated seat (Page 17) Water drain plug (Page 36) Descriptions in this manual are based on the illustrations of T1SW3014. *1 The shape and location vary depending on the type of toilet bowl and tank. *2 Except SW3004...
Preparation Using the Product for the First Time 1. Turn on the power 2. Open the shutoff valve Insert the power plug. Fully open the shutoff valve. The wand extends and then retracts. Check the "Power" LED illuminates. When the "Power" LED does not light, press for at least 3 seconds.
As the warm water tank of hot-water system is used, the temperature of warm water may become lower if it is continuously *1 To keep clean the wand every time it is used, water remaining in the wand is drained after you stand up from the toilet seat. consumed. *2 Except SW3004...
If the "Temperature adjustment" LED goes out before the setting is completed, start all over again at step 1. <Settings complete> <Settings complete> ●When the toilet seat does not get warm, or when the warm water is not warm enough, even after temperature adjustment. ➞Is the "Energy saver" set to "ON"? (Pages 20, 21) *1 Except SW3004...
Energy Saver Features Type "Auto energy saver" or "Timer energy saver" can be selected. To save energy, lower (or turn "OFF") the seat or warm water temperature. You want to save energy only You want the product to save You want to save the maximum Energy saver is on for a preset duration of time.
Page 12
Energy Saver Features How to Set Auto energy saver button Auto energy saver Timer energy saver ●Set the Energy saver at the time you want to start it. Example: To save energy from 1 am to 7 am (for 6 hours) When the time of the day reaches Timer energy saver button <The drawing is T1SW3014>...
Various Operations Setting List How to Set Available Settings Setting Types Settings Applicable Models Bold: Initial settings Ref. Page • Set whether or not to spray mist in the bowl unit Pre-mist / OFF automatically Auto Cleaning T1SW3014 Page 26 functions Features •...
Various Operations Auto functions Cleaning Features Set whether or not to spray mist in the bowl Set whether or not to deodorize automatically unit automatically after sitting on the toilet seat Pre-mist Deodorizer Press (for about 10 seconds) until all control panel LEDs fl...
Maintenance Power Plug Main Unit WARNING Power Plug Main Unit (Approximately once a month) (Approximately daily) Always unplug the power plug from the outlet before maintenance or inspection. (Failure to do so may cause electric shock or malfunction, resulting in a breakdown.) Soft cloth •...
Maintenance Gap between the Main Unit and Bowl Unit Gap between the Main Unit and the Toilet Lid Gap between the Main Unit and Bowl Unit Gap between the Main Unit and the Toilet Lid (Approximately once a month) (Approximately once a month) The toilet lid can be removed for You can remove the main unit to clean the top of the bowl unit and the bottom of the main unit.
• Do not pull, push or press the Insert the power plug. wand with excessive force. (May cause damage or • The "Power" LED illuminates. malfunction.) Press Open the shutoff valve. (Page 14) • The wand retracts. *1 Except SW3004...
What to Do? Freeze Damage Prevention If the water does not fl ow due to a water service interruption When the ambient temperature is likely to drop to 32 °F (0 °C) or lower, take measures to prevent freezing. Attention! If the water does not fl...
(to prevent scratching) ■ If the remaining water has frozen and no water comes out • Heat the inside of the bathroom, and warm the water supply hose and shutoff valve using a cloth soaked in warm water. *1 Except SW3004...
● Water may sometimes come out from around the wand when it expands in feature is not working on the frequency of use. unexpectedly from the warm water tank. ➞Check the energy saver setting. 20, 21 the wand *1 Except SW3004...
➞If the water leak does not stop, close the shutoff valve and consult with (Auto energy saver : about 79 °F (about 26 °C)) plumbing connections Heated TOTO customer service. (see contact information on the back cover.) seat Heater capacity 50 W ●...
Page 22
Damage or loss resulting from electrical surges or lightning strikes or other acts which are not the fault of TOTO or which the product is not specified to tolerate, including failure to use the factory equipped cord and plug or use of a loose or faulty electrical outlet or use of a current or socket other than a 120V, 60Hz electrical current from a GFI (ground, fused) socket.
Need help?
Do you have a question about the SW3004 and is the answer not in the manual?
Questions and answers