Elevating Grille Setting - Hitachi airPoint Room 700 Operation Manual

5. Function Menu Screen Display

5.10 Elevating Grille Setting

This function is used to raise and lower grille when the air filter and grille need to be cleaned.
It is available only when the elevating grille is equipped with the air panel.
When the air inlet grille is set inside the air panel, ensure that the air inlet grille is horizontal and the wire is
suspended tightly without loosening. After the above is ensured, set the air inlet grille. If the air inlet grille is
inclined and the wire is loosened, they may be caught in the pulley. It may lead to a failure of the pulley or pulley
block. If the worst happens, it may cause personal injury if the air panel falls open.
NOTES:
•
This function is available only for indoor unit elevating grille.
•
Make sure that the unit operation is stopped before using the elevating grille.
•
The elevating grille function is not available when the unit is operating.
1. Set the elevating grille
Step1. Select "Elevating Grille" on the "Function Menu" screen
and press "OK".
•
If there is only one indoor unit, the elevating grille
operation screen in Step3 is displayed.
Step2. Press " ", " ", " ", or " " to select the indoor unit of which
indoor unit grille needs to be raised or lowered. Press "OK".
Step3. Press " " to lower the grille until it's lowered to the set
distance.
•
If need to lower the distance further than the set
distance, press" " again.
•
Each press lowers the grille by 20in (50cm).
•
Pressing " " can stop it at any position in lowering
process.
Step4. After cleaning the air filter, install the air filter and press "
" to raise the grille. Once the grille is stored inside the unit,
it will stop after approximately 3 seconds.
•
If the grille is tilted when stored, press " " again until
the tilt is corrected.
•
Pressing " " can stop it at any position in the raising
process.
Step5. Press" " to return to the indoor unit selection screen.
To operate other indoor units, perform the operations of above Step2.
To end the operation, press " " again to return to the "Function Menu" screen.
•
If there is only one indoor unit, the screen returns to the "Function Menu" screen.
32
Function Menu
Elevating Grille
Reset Filter Reminder Time
Filter Cleaning
FrostWash Setting
Individual Louver Setting
Select
OK
Elevating Grille
ALL
01-01
01-02
01-03
01-04
OK Select
Refrigerant System No. – Address No.
Elevating Grille
All
Press to raise/lower Grille.
A16381TMEU
(Mon) 16:30
Back
UPDW
Back
UPDW
Back