Evenflo REVOLVE 360 SLIM Owner's Manual page 78

10. Apply pressure to fully close the
LockStrong. The lock indicator will
turn GREEN when fully closed.
NOTE: If belt tensioner does not fully
close (lock indicator still RED), open
the LockStrong and try loosening the
LATCH/UAS strap slightly.
11. Grab Base near belt path as shown
and pull side to side and front to back
to make sure Base is installed tightly.
Base should not move more than 2.5
cm (1 in) side to side or front to back
at the Belt Path on the Car Seat.
If Base moves more than 2.5 cm
(1 in), open LockStrong, tension
LATCH/UAS strap a little more, and
try again. If Base still moves too
much, you may need to try a different
78
LATCH/UAS (Rear-Facing and Forward-Facing)
Installing LATCH/UAS