Environment Commands; Help, H, ? [Command]; Hexadecimal, Decimal; Verify [On | Off] - Fujitsu F2MC-16L Series User Manual

3.3. Environment Commands

3.3.1.

HELP, H, ? [Command]

Print Help Text
The HELP command prints a short overview of the most important monitor commands.
Shortcuts for this are H and ?.
If a command is named, specific help is displayed.
>help d↵
... Displays all commands with 'D' as first letter.
3.3.2.

HEXADECIMAL, DECIMAL

Specify Default Input Mode
The HEXADECIMAL or DECIMAL command specifies the default format of numbers
required for command parameters.
Power On default is HEXADECIMAL.
>decimal↵
... Changes to decimal input format.
3.3.3.

VERIFY [ON | OFF]

Enable/disable Memory Write-Read-Verify mode
Most of memory accesses requested by the user via monitor are back-read if VERIFY mode it
is set. Correct writing can be checked this way. Without parameter the current mode is
displayed otherwise it is set as requested.
Power on default is ON.
>verify off↵
... Disables the write-verify-check.
NOTE: Some peripheral controller registers or board registers are write-only or have different
function when read or are valid only for one read access. These registers will always
cause an ERROR-message.
E.g. if UART data register is written to for sending one char (by EDIT-command)
and it is re-read, a possible received character lost. Switch VERIFY off if such
registers are manually edited.
NOTE: If VERIFY is switched off the correct writing of break/trace points is not checked.
Therefore, VERIFY should be disabled only if necessary.
3.3.4.

UPDATE [CHANGE | ALWAYS]

Change colouring mode of REGISTER command
© FUJITSU Mikroelektronik GmbH 1996
FUJITSU MB90675-Evaluation Board - User Manual
- 19 -