Using This Unit - JVC HC-CW1F Instructions Manual

Once the driver software has been installed and the PC has been restarted, you can
connect this unit to the PC and start using it.
1. Connect the provided USB cable to the USB cable connector of this unit.
• The plugs at either end of the USB cable are different. Connect the appropriate
plug to the connector.
2. Connect the other end of the USB cable to the USB port on the PC.
The operating system will automatically recognize this unit and three removable
disk icons are displayed in My Computer (Fig. 5).
The displayed removable disk drives are assigned drive letters in alphabetical
order, excluding (B:).
The drives are assigned to the three memory slots for SmartMedia, PC Card/
CompactFlash and SD Memory Card/MultiMediaCard in order.
(e.g. 1: A: FDD, C: HDD, G: CD-ROM)
D: SmartMedia
E: PC Card/CompactFlash
F: SD Memory Card/MultiMediaCard
(e.g. 2: A: FDD, C: HDD, F: CD-ROM)
D: SmartMedia
E: PC Card/CompactFlash
G: SD Memory Card/MultiMediaCard
Notes
• The first time you use this unit after installing the driver software, you will see
the OS recognition process on-screen. Once this unit has been recognized,
this process display goes out automatically.
• If the unit is connected to a PC and the PC does not recognize it, check to see
if the USB port is set to [Disable].
If the port is disabled, do either of the following:
1. Set all devices in the [universal serial bus control] to [Enable] with the OS
device manager.
2. With the PC BIOS setting, set the USB port to [Enable]. For device manager
and BIOS setting, refer to the PC's instruction manual.
Downloaded from: https://www.usersmanualguide.com/

USING THIS UNIT

Fig. 5
11