6.
Remove the TouchPad button board and cable (5).
Reverse this procedure to install the TouchPad button board and cable.
Optical drive connector cable
Description
Optical drive connector cable
Before removing the optical drive connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see Battery), and then remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
WLAN module (see
d.
Keyboard (see Keyboard)
e.
Top cover (see
52
Chapter 4 Removal and replacement procedures
This manual downloaded from http://www.manualowl.com
Hard
drive)
Optical
drive)
WLAN
module)
Top
cover)
Spare part number
700011-001