Yamaha NAVIGO Owner's Manual page 97

● Attach the hook-and-loop fastener (male) at both edges of belt to entire surface.
(7) Slide the belt and adjust the two (2) belt edges to the vi-
cinity of vehicle center as much as possible.
● The belt edges should not be near the frame or touching moving parts (as shown incorrectly
in the "NG" inset drawing).
● Make sure the belt is taut. A slack or loose belt could allow the battery bag to come off or the
belt could get caught in moving parts.
(8) Feed the band part of battery bag through upper side
frame and fix the belt by using fitting tape (Hook-and-loop
fastener of male at both sides).
There are two (2) ways for fitting tape attaching methods
as follows; Select the method adequate to the wheel-
chair you are using and attach the tape.
NOTICE
NOTICE
Band Part of
Battery Bag
Frame
Belt
Belt Edge
NG
Frame Belt
Belt Edge
Frame
Battery Bag
11
91