A T T A C H I N G T H E W E L D I N G W I R - Panasonic YD-200KR Operating Instructions Manual

CHECKS AND PREFARATIONS PRIOR TO OPERATION
 Attaching the welding wire
 Attach a feed roller in
the direction
allows you to see the
same numeral as the wire
diameter used.
figure above shows an
example of
"l.2" of the 0.9/1.2
feed roller)
Wire
Correction Roller
⑨Pull out the welding wire. Insert it
into the CC fixture, putting it
through the correction rollers
(Wire guide for the 200KR2/350KR2)
which
(The
attaching
Pressure
Nut
②Shaft
down
CC Fixture
Wire Stopper
Hole
Knob Screw
Spool Clamping Washer
⑩Put back a pressure arm and pressure nut in
that order.
③Lift up.
Correction Adjusting Bolt
Feed Roller
⑤ Loosen a knob screw to remove a spool clamping
washer.
⑥Attach the welding wire to the spool fitting. (In the
clockwise direction of the wire spool)
⑦Put back the spool clamping washer and tighten the
knob screw.
⑧Remove a wire stopper from the outer edge of the wire
spool.
(Be careful of the wire jumping up of getting loose)
(11)Turn the pressure nut to make a pressurization
force
commensurate with a diameter of the welding wire.
１３
Pressure
Arm
④Loosen a lock nut
a n d c o r r e c t i o n
adjusting bolt in
tha t or de r
(Not required for
the 200KR2/350KR2)
Wire
Make sure that the
1
Correction
m o u n t e d f e e d
Roller
roller conforms to
Lock nut
a diameter of the
w e l d i n g w i r e .
BASICS
.