Change Units; Alarms; Simulate Mode - NorthStar NS3100 Multi Instrument Reference Manual

2-3 Change units

2-4 Alarms

2-5 Simulate mode

6
To change the speed and log units, press
Speed is displayed, then hold
change; if necessary, hold
change again.
To change the depth units, press
displayed, then hold until the units change; if
necessary, hold until the units change again.
The NS3100 Multi can be set to sound an alarm
when the water is too deep or too shallow (see
sections 5-2 and 5-3). When the alarm sounds, the
internal beeper sounds, the
flashes and any external beepers or lights operate.
Simulate mode allows you to become familiar with
the unit off the water. In Simulate mode, the NS3100
Multi functions normally except that the transducers
are ignored and the unit generates this data
internally. The word SIMULATE flashes at the bottom,
right corner of the screen.
until
until the units
again until the units
until DEPth is
Press
until the depth becomes returns to the pre-alarm
condition or is within the alarm parameters. The
symbol on the display
alarm will sound if the depth becomes too deep or
too shallow again.
To turn Simulate mode on or off:
1 Turn the power off.
2 Hold down
To change the temperature units, press
the temperature is displayed, then hold
the units change.
to mute the alarm. The alarm stays muted
while you turn the power on.
Northstar NS3100 MULTI
until
until