Table of Contents
Advertisement
AUTODOME 7100i│AUTODOME 7100i IR
8
(Optional) Installing an SD card
Notice!
i
Risk of damage to the bubble
Handle the bubble with care. Do not scratch the inside of the bubble which doesn't have a
hard coating.
Notice!
i
Use full size SD cards for maximum reliability. Bosch doesn't recommend the use of microSD
cards or of microSD to SD adapters.
Notice!
i
Before adding or removing a full size SD card from the camera, disconnect all power sources
(including PoE) from the device.
1.
2.
3.
4.
5.
6.
7.
8.
Bosch Security Systems
Disconnect power to the camera while adding or removing an SD card.
Push the compliant beam using a small tool (less than 3 mm) through the hole on the tilt
body. Note: The mentioned tool is not included.
Hold and twist on the space on the camera that releases the latch to hold the bubble to
the housing until the bubble starts to rotate, as in number one in the graphic that follows.
Turn the bubble clockwise 10 degrees while pressing the tool against the button.
Remove the tool once bubble starts to rotate.
Lift the bubble off the camera.
Insert the card into the slot. Note: Do not force the card into the slot. If the card isn't
going in, it may be backwards.
Using a flathead screwdriver, push down on the SD card until it locks into position.
3
Installation Manual
(Optional) Installing an SD card | en
2
1
1
21
2023-02 | V01 |
Advertisement
Table of Contents
