KitchenAid 3KSM55 Manual page 5

PRODUCT ASSEMBLY
3
To attach the Accessory: Slip the
accessory onto the shaft. Turn to hook it
over the pin on the shaft.
IMPORTANT: If the Bowl is not securely snapped into place, it will be unstable and
wobble during use.
5
To raise the Bowl: Rotate the
Bowl-Lift Lever to the straight up
position. The Bowl must always be in the
raised position when mixing.
7
Lower Bowl Lower Bowl
Raise Bowl Raise Bowl
(OPTIONAL) To adjust Beater to Bowl
Clearance: Lower the Bowl to the
down position. Turn the screw slightly
counterclockwise (left) to raise the beater,
or clockwise (right) to lower it. Adjust the
beater so that it just clears the surface of
the Bowl. Check again the clearance of
the beater to the Bowl.
*Included with select models. Picture/Style may vary from product depending on model.
W11556523B.indb 5 W11556523B.indb 5
Pin
4
To remove the Accessory: Turn Stand
Mixer to OFF/0 then unplug. Press
accessory upward and turn to the left. Pull
down the accessory from Beater Shaft.
6
Test the Beater to Bowl Clearance: Turn
Stand Mixer ON and test each speed,
making sure the beater does not touch
the Bowl during operation. If the Beater
is too far away from the bottom or is
hitting the Bowl, proceed to next step to
make adjustments.
IMPORTANT: When properly adjusted,
the Flat Beater will not strike on the
bottom or sides of the Bowl. If the Flat
Beater or the Wire Whip* is so close that
it strikes the bottom of the Bowl, coating
may wear off the beater or wires on the
whip may wear.
5
8/18/2022 11:34:27 AM 8/18/2022 11:34:27 AM