Setting The Ip Address On The Pc - ABB L240 Product Manual

3.3.1 Setting the IP address
on the PC
Software WIN-PC for Intrusion Alarm Panel L240
• As soon as the IP module is supplied with voltage, the Intrusion Alarm
Panel will be informed of the set PC function.
• Green LED 1 indicates correct communication with the Intrusion Alarm
Panel by fast flashing.
• The three yellow LEDs indicate the function of the LAN interface.
The "Ethernet" LED lights when connected to a network. The "Data"
LED flashes during function data transmission and the "Collision" LED
lights up in the event of a fault.
• After commissioning, remove jumpers LK1 and LK2 and close the
enclosure cover.
Note:
Only one Interface Module L208/V.24 or L240/IP can be operated on the
panel at any time.
The Interface Module L240/IP requires a fixed IP address setting for ope-
ration. The network section of the address (defined by the subnet mask)
must comply over the entire network. The device section of the address
(generally the last number block) is used for addressing the individual
devices.
In the example configuration, the following IP addresses are assumed
(can vary according to the network):
• PC: 192.168.3.1
• L240/IP: 192.168.3.3
• Gateway: 192.168.3.4
Generally, the properties of the Internet protocol for the PC settings are
set to "Obtain an IP address automatically". This setting must be checked,
and a fixed IP address setting may need to be set.
The following example shows how the IP address of the computer is
changed (Example: Windows XP).
Note:
The settings must be made by a person with appropriate experience in
the configuration of PCs and network technology. Consult your system
administrator if required.
• Access the network settings:
Start – Control Panel - Network and Internet Connections.
• Double click on the respective network connection under
LAN or High-Speed Internet and click on Properties.
• The window >Properties of LAN Connection opens.
Select Internet Protocol (TCP/IP) from the list and click on Properties.
• Activate "Use the following IP address" and enter the new IP address
(in our example the IP address 192.168.3.1) and Subnet Mask.
IMPORTANT: Note the old IP setting so that you can reactivate it!
7