Panasonic DVCPRO50 Service Manual page 151

(Auto EQ Adjustment Procedure)
A) Preparation
1) Connect the VTR with PC by RS232C cable (Cross cable) as below.
Connect the VTR with personal computer by RS232C cable (Cross cable) as below.
RS-232C cable (Cross cable)
2) Turn the VTR power on.
3) Press the menu button to open the set-up menu.
4) Select 070 TV SYSTEM and set it to "525".(only AJ-SD955A)
5) Select 204 RS232C SEL and set it to "ON".
6) Set the LOCAL/ REMOTE SW to "ON".
B) Excution of Software Application.
1) Confirm that the VTR power is on.
Select start → Program → Panasonic Tool → D955Rf in the Start menu program in PC.
2)
3) Main screen of the application software appears.
4) Open the program menu and select as follows;
Adjustment: Select "Program → → → → Adjust".
Measurement: Select "Program → → → → Error Rate".
5) Select the item needed about adjustment & measurement from. Adjustment/ Measurement item selection
BOX (refer to (a-2)).
Select "Program → → → → Start"
6)
7) Serial no is displayed. Press "OK" button. (The information on this window can be changed and added.)
8) Follow the indication on the message box. Then adjustment is started automatically.
9) Error result is displayed after excuting the adjustment program. Press close button after confirming it.
10) Select "File → → → → Save" in order to save the Error rate data & EVR data to PC. If it is not needed to save
them, skip this process.
(Caution)
This item can not be functioned unless "Data Download", "Load on File menu" or all adjustment program is
excuted.
11) The screen of item (7) appears again. Press "OK" button if serial data information is not needed to change.
PC
VTR
Figure A
ELE-10
RS-232C Terminal
(Rear Jack)
Alignment Tape for
this Adjustment.
·VFM3580KM/KL
·VFM3010EDS
·BLANK TAPE