Table of Contents
Advertisement
CONFIGURATION
General
The IRRInet-M DC unit can be configured using the ACE3600 System Tools Suite (STS). A
default configuration is provided when the RTU is shipped from the factory. If any changes to
the configuration are made by the user (e.g. updating the site ID), this new configuration is
downloaded to the unit. If a user-defined configuration is downloaded and then erased, the
default configuration will be used.
For information on changing the RTU configuration and downloading it to the unit, see the
ACE3600 RTU STS User Guide.
Port Configuration
The default port configurations are:
•
Port 1: RS232 57,600 bps
•
Port 2: RS232 RTU to RTU, 9600 bps
•
Port 3: Radio DPSK, 1200 bps with Auxiliary DC power level of 7.5V
To change the default port configuration, use the STS. For information on configuring the
ports, see the ACE3600 RTU STS User Guide.
For general radios with positive PTT polarity, change the 'Radio PTT
Polarity' advanced parameter in the STS site configuration before using
the radio.
I/O Configuration
The default I/O configuration includes Main board I/Os only (4DI/12DO). To add Expansion
board I/Os or modify I/O parameter settings, use the STS. For information on configuring the
I/Os, see the ACE3600 RTU STS User Guide.
Advanced Parameter Configuration
A set of advanced parameters can be configured and downloaded to the IRRInet-M RTU using
the STS. These relate primarily to the communication and I/Os. To change the default settings
for advanced parameters, use the STS. For information on configuring the advanced
parameters, see the ACE3600 RTU STS User Guide.
27
Advertisement
Table of Contents
