Installation of IRRInet-M with Waris External Radio
IRRInet-M models, which are equipped with external radios (GP320/GP328/HT750/
PRO5150), should be connected as described in Installation of IRRInet-M with
GP320/GP328/HT750/PRO5150 Radio in Appendix B below.
The IRRInet-M Radio Kit Assembly enables users to install a GP320, GP328, HT750,
PRO5150 radio (externally) to the IRRInet-M.
Before connecting the radio, verify that the IRRInet-M has been configured
for the proper radio type.
Portable radios are powered from 7.5V DC only.
Miscellaneous
Open the Case Door
To open the case door properly, press the two clips (latches) and pull the wing to an open
position.
Close the Case Door
To close the case door properly, press until the latch clicks. If the cable connections are not
threaded properly through the cable holes, the cable cover may not close.
Fixed Site Antennas
The antenna installation must comply with the following requirements in order to assure
optimal performance and make sure human exposure to radio frequency electromagnetic
energy is within the guidelines set forth by the local regulations.
The antenna must be mounted outside the building.
Mount the antenna on a tower if at all possible.
If the antenna is to be mounted on a building, then it must be mounted on the roof.
As with all fixed site antenna installations, it is the responsibility of the licensee to manage the
site in accordance with applicable regulatory requirements. This may require additional
compliance actions such as site survey measurements, signage, and site access restrictions in
order to ensure that exposure limits are not exceeded.
Installation
25