Table of Contents
Advertisement
Quick Links
Network Camera
Installation Guide
EN
Please be sure to read the "Safety Precautions" section for correct use.
Caution
Request a professional installer for all installation work. Never try to install
the camera yourself. Doing so may result in unforeseen accidents such as
dropping the camera or electric shock.
Some cameras are not available in certain countries or regions.
/
21.0 (0.83)
43.2 (1.70)
54.5 (2.15)
9.5 (0.37)
Φ4.8 (Φ0.19)
Unit: mm (in.)
Advertisement
Table of Contents
Related Manuals for Canon VB-S32D
Summary of Contents for Canon VB-S32D
- Page 1 Network Camera Installation Guide 43.2 (1.70) 21.0 (0.83) 54.5 (2.15) Φ4.8 (Φ0.19) 9.5 (0.37) Unit: mm (in.) Please be sure to read the “Safety Precautions” section for correct use. Caution Request a professional installer for all installation work. Never try to install the camera yourself.
- Page 2 This document has been prepared with the utmost attention to accuracy. If you have any comments, however, please contact a Canon sales representative. Canon shall assume no liability for any outcome of using this product, notwithstanding items listed above. ■...
-
Page 3: Part Names
Part Names S820 Camera head Top cover Memory card cover Rotation dial S820 Rating label Tripod mounting screw hole Audio input terminal External device I/O terminals 100 Base-TX LAN connector Safety wire mounting section Label * 1: A 1/4-20 UNC tripod mounting screw less than 5.5 mm (0.22 in.) in length will fit the screw hole. * 2: It is recommended to write down the serial number and MAC address. -
Page 4: Before Installing The Camera
Before Installing the Camera When Using a Memory Card Insert a memory card before installing the camera. Memory Card Slot Reset switch (see “Operation Guide”) To remove the memory card, push it in all the way until the card slightly pops out and remove. -
Page 5: Installing The Camera
Installing the Camera Template S820 Wall installation FRONT S820 Wall installation Φ 30 mm (1.18 in.) - Page 6 Installing the Camera Anchor or structure Safety Wire M4 x (1)
- Page 7 Installing the Camera LAN cable For power supply, refer to “Power Supply” (P. 12) . For network terminal, refer to “Interface” (P. 16) Status When power supply is on, restarted, or in normal use (when set to “ON”*) Blinking Updating the firmware, or initializing settings Lights up for a few seconds at startup, then turns off (when set to “OFF”*) * Refer to “Operation Guide”...
- Page 8 Installing the Camera If using the External Device Terminal or Audio Terminal Protective cover for audio input terminal Audio input terminal Protective cover for external device I/O terminal External device I/O terminal Refer to “Audio Input Terminals Common for LINE IN/MIC IN” (P. 14) for details.
- Page 9 Installing the Camera Be sure to prepare mounting screws separately. (Nominal diameter: M4, Head Shape: pan, x 3)
- Page 10 Installing the Camera S820 Important S820 hosts may appear on the screen depending on the external light angle of • G incidence. Perform fine adjustment of the camera orientation.
- Page 11 Installing the Camera Adjust the camera angle on the Settings page. (Refer to “Operation Guide”.) Important • Ghosts may appear on the screen depending on the external light angle of incidence. Perform fine adjustment of the camera orientation.
-
Page 12: Connecting The Camera
Power Supply For details, refer to “Other” > “Power Supply” (P. 17) . For PoE powered devices, check with a Canon's sales representative. Some PoE devices allow power limits for each port, but applying limits may interfere with performance. In this case, use without any restrictions. - Page 13 Connecting the Camera ■ External Device Input Terminal The external device input terminal consists of an IN terminal and a GND terminal. Connecting wires to the IN and GND terminals and opening or closing the circuit notifies the Viewer. Important •...
- Page 14 Connecting the Camera Audio Input Terminals Common for LINE IN/MIC IN Camera has a single audio input system supporting two types of microphone input: LINE IN and MIC IN. Before use, change [Audio Input Mode] on the Setting page (refer to the “Operation Guide”).
- Page 15 Accessories The following dedicated accessories can be purchased separately as necessary. (Some accessories are not available in certain countries or regions.) Pendant Mounting Kit PC30-VB Dedicated accessory used to install the camera to the end of pipe that extends from high ceilings, such as in big-box stores.
-
Page 16: Specifications
Specifications For specifications not listed below, refer to Network Camera's “Specifications”. ■ Camera 3.5x optical zoom (4x digital zoom) lens with auto focus Lens Fixed focal length lens (4x digital zoom) S820 Angle of View For 16:9 aspect ratios Horizontal: 79.0° (W) – 20.9° (T) Vertical: 41.0°... - Page 17 Specifications ■ Others Operating Environment Temperature: PoE: -10°C – +45°C (+14°F – +113°F) Humidity: 5% – 85% (without condensation) Storage Environment Temperature: -30°C – +60°C (-22°F – +140°F) Humidity: 5% – 90% (without condensation) Power Supply PoE: PoE power supply via LAN connector (IEEE802.3at Type1 compliant) Power Consumption PoE: Max.
-
Page 18: Safety Precautions
• Depending on the computer and network environment, high-precision video transmission cannot be guaranteed due to due to video latency or loss of video. Canon will assume no liability for any accident or damage resulting from use of the camera under the conditions above. - Page 19 Caution Failure to follow the instructions may result in injury. For installation or inspection of this camera, consult a Canon's sales representative. • Network/power wiring should be made by a qualified service person and should conform to all local codes.
- Page 20 Safety Precautions Important • Installation of a lightning arrester (a surge protection device) is recommended as a measure against failures caused by lightning strikes. • Do not turn the camera head by hand. • Do not install the camera on an unstable surface. •...
- Page 21 • Please be advised that Canon shall not be liable in any way in the event of a dispute between any user and any third party concerning the installation of the product or...
- Page 22 © BIE-7313-001 CANON INC. 2022...