Quick Start - NEC MultiSync M500 User Manual

Quick Start

To attach the MultiSync
these instructions:
1. Turn off the power to your computer and MultiSync monitor.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the MultiSync M Series 15-pin mini D-SUB of the captive
combined signal cable to the connector of the display card in your system
(Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync M Series Macintosh cable adapter (not
included) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive combined signal cable to the Macintosh
cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync M Series cable adapter, call
NEC Technologies at (800) 820-1230.
78133441
M Series monitor to your system, follow
®
15-pin mini D-SUB
Figure A.1
Computer
Figure B.1
2
4
Captive Combined
Signal Cable
Captive Combined
Signal Cable
Mac Adapter
(Not included)
15-pin mini D-SUB
6/24/98, 7:50 AM