Inflation Pressure; Connecting The Battery Cables; Checking Tire Pressure - Cub Cadet Pro Z SurePath Auto Steer Series Operator's Manual

Seat Lumbar
To vary the lumbar support move the lever on the right of the seat up and down. See
Figure 16.
Seat Arm Rest
To adjust the height of the arm rests, lift the arm rest and rotate the knob under the
arm rest right or left to increase or decrease the height. See Figure 17.
Seat Air Ride
The air ride can be adjusted up or down using the height adjustment lever (a) on the
front of the seat. Press the lever to the left (+) to raise the height of the seat and to
the right (-) to lower the height of the seat. See Figure 18.

CHECKING TIRE PRESSURE

Maximum tire pressure under any circumstances is 12 psi on rear tires and 25
psi on front tires. Equal tire pressure should be maintained at all times.
Figure 16
Figure 17
a
Figure 18
WARNING
SET-UP

INFLATION PRESSURE

Rear Tires — 10-12 psi max
Front Tires — 20-25 psi max
The tires on your mower may be over-inflated for shipping purposes. Reduce the tire
pressure before operating the mower. Recommended operating tire pressure is 10-12
psi on rear tires and 20-25 psi on front tires.
LUBRICATION & GREASE POINTS
Before operating the mower, refer to the Product Care section of this manual to check
the lubrication and grease points. Grease and lubricate if necessary.

CONNECTING THE BATTERY CABLES

CALIFORNIA PROPOSITION 65: Battery posts, terminals, and related
accessories contain lead and lead compounds, chemicals known to the State
of California to cause cancer and reproductive harm. Wash hands after
handling.
When attaching battery cables, always connect the POSITIVE (Red) wire to
its terminal first, followed by the NEGATIVE (Black) wire.
For shipping reasons, both battery cables on your equipment may have been left
disconnected from the terminals at the factory. To connect the battery cables,
proceed as follows:
1. Using the lever on either side of the back of the seat, lift up on the lever and tilt
the seat forward locking it in place with the seat prop. Remove the bolts and
hex nuts from the manual bag.
NOTE: The positive battery terminal is marked POS. (+) (a). The negative
battery terminal is marked NEG. (–) (b). See Figure 19.
NOTE: If the positive battery cable (c) is already attached, skip ahead to Step 4.
2. Slide the red boot (d) from the positive battery terminal (a) and attach the red
cable (c), with the vertical mount bolt (e). See Figure 19.
3. Position the red boot (d) over the positive battery terminal (a) to insulate it and
help protect it from corrosion.
4. Attach the black cable (f), to the negative battery terminal (b) with the vertical
mount bolt (e). See Figure 19.
NOTE: If the battery is put into service after the date shown on top/side of
battery, charge the battery prior to operating the machine.
CONNECTING TO THE GPS NETWORK
See the Operation section for instructions on connecting to the GPS Network.
12
WARNING
CAUTION
e
e
c
a
f
b
Figure 19
d