Removing And Installing Engine; Removing And Installing Engine Trim Panel; Removing Engine - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
10 –

Removing and installing engine

1 Removing and installing engine
⇒ "1.1 Removing and installing engine trim panel", page 10
⇒ "1.2 Removing engine", page 10
⇒ "1.3 Securing the engine to the assembly stand", page 23
⇒ "1.4 Installing engine", page 25
1.1 Removing and installing engine trim
panel
Caution
When removing and installing the engine trim panel, where
applicable, prevent a collision with the fuel return-flow line or
prevent coming into contact with the lines by accident. In un‐
favourable situations, the outlets on the injectors may break
off. This can cause leaks in the fuel system.
The brackets of the engine cover on the cylinder head cover
can break off when they are incorrectly removed.
♦ It is therefore necessary to remove the engine cover ac‐
cording to the following instruction.
– Carefully pull the engine cover off the retaining bolts one after
another -arrows-. Do not pull engine cover off in jerks or on
one side.
Install
– To avoid damage, do not strike the engine cover with the fist
or a tool.
– Position the engine cover paying attention to the oil fill sup‐
ports and dipstick.
– First press the engine cover into the rubber grommets on the
left side, then into the rubber grommets on the right side.
1.2

Removing engine

Special tools and workshop equipment required
♦ Removal tool for inner lining of the door panel - MP8-602/1-
♦ Engine and gearbox jack - V.A.G 1383 A-
♦ Double ladder
♦ Screw plug set for engine - VAS 6122-
♦ Catch pan , e.g. -VAS 6208-
♦ Hose clip pliers - VAS 6362-
♦ Locking pin - T10060 A-
♦ Engine mount - T10497- with bolts -T10497/1-
♦ Protective goggles
♦ Protective gloves
10
Rep. gr.10 - Removing and installing engine