Accessories And Installation Tool; Before Using Atw Wireless System - Mitsubishi Electric ecodan PAR-WT50R-E Installation And Setting Manual

2. Accessories and Installation Tool

The following items are included in the box.
Wireless receiver <PAR-WR51R-E>
(2 m long cable included)
Bracket
Flat head screw (4.1 × 6)
Installation and setting manual
* Installing of the devices requires a Phillips-head screwdriver (No.2 6 mm).

3. Before using ATW wireless system

Following is the summary of the procedure for installing and setting the wireless system.
1. Devices and manuals required to set and install the wireless system
PAR-WT50R-E wireless remote controller
PAR-WR51R-E wireless receiver
ATW wireless system installation and setting manual (this manual)
Wireless remote controller operation manual (hereinafter abbreviated as OM)
Ecodan system installation manual (hereinafter abbreviated as IM)
2. Installing and setting procedure
Power off the ecodan system.
Install the wireless receiver on the ecodan system.
(See "4. Installing the Wireless Receiver" in this manual.)
When installing the wireless receiver, be sure to set the SW1-8 on the control
board to ON. (See "5.1 DIP Switch Functions" in IM. )
Power on the ecodan system, and the LEDs will blink on the receiver for 3 seconds.
Place two AA alkaline batteries in the wireless remote controller.
(See "·Batteries" in "4. Before Operation" in OM.)
Perform pairing process between the wireless receiver and the remote controller.
(See "5. Pairing process" in this manual.)
The wireless receiver does not go through a pairing process unless the ecodan
system is off. When the system is ON, be sure to turn it off before beginning the
pairing process.
3
Part name No.
1
1
4
1