Automatic Zone No. Display - Mitsubishi Electric ecodan PAR-WT50R-E Installation And Setting Manual

When the indoor unit is operating, the room tem-
perature display shows the actual room tempera-
ture (18°C) below and the set temperature (20°C)
above as shown in the figure to the right. The meas-
urable temperature range is from 0°C to 40°C.
If the measured room temperature is out of
0°C to 40°C range, the room temperature
display blinks.
When the wireless remote controller is installed on a bracket, room temperature might
not be accurate being affected by the wall temperature.
Perform a test run and place the remote controller where the room temperature can
be correctly detected.
6.6. Automatic Zone No. Display (Mode No. 5)
Set the mode no. to "5".
When the automatic zone no. display is ac-
tive, a zone number assigned to the remote
controller is displayed for 3 seconds after
temperature setting.
Press or button to select between "
" and or
save setting.
Inactive :"
Active :The zone no. (
signed to the remote controller
is shown.
15
, and press button to
".
or
<Inactive>
<Active>
) as-