Symptoms - Husqvarna AUTOMOWER 450X Operator's Manual

6.6 Symptoms

If the product does not operate correctly, refer to the symptoms table below.
Symptoms
The Main switch is set to the
0 position but the product is
not set to OFF.
The product cannot go into
the charging station.
The product operates at the
incorrect time.
There is vibration in the prod-
uct.
The product operates, but the
blade disc does not rotate.
The product operates for
shorter periods than usual
between charges.
Operation and charging times
are shorter than usual.
34 - Troubleshooting
Cause
The Main switch is set to the
tion but the product is not connected to
®
the Automower Connect app with Blue-
®
tooth . The product is disabled but not
set to OFF.
The charging station is not on a level sur-
face.
The charging station is put too far from
the work area.
The time and date of the product must be
set.
The start and stop time for operation are
incorrect.
The cutting system is not in balance be-
cause of damaged blades.
The cutting system is not in balance be-
cause of too many blades in the same
position.
Blades of different thickness are installed
on the product.
The product goes to the charging station. Usual operation of the product. The
Grass or other object causes a blockage
to the blade disc.
The battery is at the end of its life cycle.
The grass is high and thick.
The battery is at the end of its life cycle.
Action
0 posi-
Set the Main switch to the
connect the product to the Automower
Connect app with Bluetooth
Main switch to the
Put the charging station on a level sur-
face. Refer to To examine where to put
the charging station on page 11 .
Make a new work area or move the
charging station.
Set the time and date. Refer to
date on page 20 .
Change the schedule settings. Refer to
Schedule on page 18 .
Examine the blades and screws and re-
place them if necessary. Refer to
place the blades on page 25 .
Do a check that only one blade is attach-
ed to each screw.
Examine if the blades are of different
thickness and replace the blades if nec-
essary.
blade disc does not rotate when the
product goes to the charging station.
Remove and clean the blade disc. Refer
To clean the chassis and blade disc on
to
page 24 .
Replace the battery. Refer to
page 25 .
Increase the cutting height and then de-
crease it when the grass is shorter.
Replace the battery. Refer to
page 25 .
1 position,
®
®
and set the
0 position.
Time &
To re-
Battery on
Battery on
1970 - 001 - 10.10.2022