Husqvarna AUTOMOWER 450X Operator's Manual page 16

A work area is specified by virtual boundaries. Maximum
20 work areas and secondary areas can be installed on
a map.
There are two types of work areas:
• A work area that has a charging station in it or
connected to it with a transport path where the
product operates automatically.
• A secondary area is a work area with no charging
station and no transport path. The product must be
moved manually to and from the work area.
A transport path is a specified path between the docking
point in front of the charging station and a work area.
The product can operate automatically in this path, but
does not cut grass. A transport path can temporarily be
enabled and disabled in the app.
Stay-out zones can be made if there are areas where
the product must not operate. A stay-out zone is
specified by virtual boundaries. Stay-out zones can
temporarily be enabled and disabled in the app.
A maintenance point is a specified position where the
product can be parked at. This can for example be used
for a service point where maintenance of the product
is done. The maintenance point is connected to the
docking point with a path.
To install objects on the map, operate the product with
the appDrive installation to add waypoints on the map.
To install objects on the map on page 16 .
Refer to
3.8.7.1 To install objects on the map
The waypoints (A) are positions that makes the virtual
boundaries and paths (B). The lines are straight
between the waypoints. Add a number of waypoints to
make smooth curves. You can adjust the positions of the
waypoints in the app after the installation of the map.
A
CAUTION:
Do not lift and move the
product between the waypoints when you
install the map objects. Use appDrive for a
correct installation.
16 - Installation
Note:
work area or a stay-out zone is in the front left corner of
the product.
Note:
transport path or a path to a maintenance point is in the
middle of the product between the drive wheels.
•
•
•
B
•
•
•
•
•
•
The position of the waypoint when you install a
The position of the waypoint when you install a
Make sure that you are near the product and
connected to the product with the app with
®
Bluetooth .
EPOS confirmed in the
Make sure that the status is
appDrive.
Select the object you want to install and use the
buttons in the appDrive installation to operate the
product.
Use the up button (A) to move the product forward.
Use the down button (B) to move the product
rearward.
Use the left arrow button (C) to rotate the product
to the left.
Use the right arrow button (D) to rotate the product
to the right.
Use the center button (E) as a joystick to move and
rotate the product in any direction.
Use the waypoint button (F) to add a waypoint in
the map.
1970 - 001 - 10.10.2022