Husqvarna AUTOMOWER 450X Operator's Manual page 14

1. Install the reference station. Refer to the
Operator's manual for the reference station.
2. Install the charging station. Refer to
charging station on page 14 .
®
3. Install the Automower
mobile device. Refer to
Connect app on page 15 .
4. Do a pairing operation of the product and the
®
Automower Connect app. Do the basic settings in
the start up sequence in the Automower
To install the Automower
app. Refer to
app on page 15 .
5. Make a map with work areas, stay-out zones,
transport paths and maintenance points. Refer to
To install objects on the map on page 16 .
®
6. Use Automower Connect app to do settings for
Settings on page 18 .
the product. Refer to
3.8.2 Installation tools
• Hex key, 8 mm. Included in the carton.
3.8.3 Installation of the charging station
Read and understand the instructions about the
To examine where to put the
charging station. Refer to
charging station on page 11 .
CAUTION:
Do not make new holes in
the charging station plate.
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
When you connect the power supply, only use a power
outlet that is connected to a residual-current device
(RCD).
3.8.3.1 To install the charging station
1. Put the charging station in the selected area.
2. Attach the charging station to the ground with the
supplied screws.
3. Connect the low-voltage cable to the charging
station.
4. Put the power supply at a minimum height of 30
To examine where to put the
cm / 12 in. Refer to
power supply on page 12 .
14 - Installation
To install the
Connect app on your
®
To install the Automower
® Connect
® Connect
Make sure that the plugs of
min 30 cm / 12"
5. Connect the power supply cable to a 100-240V
power outlet.
6. Put the low-voltage cable in the ground outside the
work area. Use stakes or bury the cable.
7. Put the product in the charging station to charge
the product.
3.8.3.2 To do a visual check of the charging station
1. Make sure that the indicator LED lamp on the
charging station has a green light.
2. If the indicator LED lamp does not have a green
light, do a check of the installation. Refer to
install the charging station on page 14 and LED
indicator lamp on the charging station on page
33 .
3.8.4 Installation of the reference station
Install the reference station according to the instructions
in the Operator's manual for the reference station.
®
3.8.5 Automower Connect
®
Automower Connect is a free app for your mobile
device. Use the app for installation, settings and
operation of your product. You can also find more
information for example about alarm and statistics in the
®
Automower Connect app.
The app gives 2 modes of connectivity: Long-
range cellular connectivity and Short-range Bluetooth
connectivity.
• Dashboard that shows the current status of the
product and the battery state of charge.
• Account shows an overview of the account settings
and the unit format can be set.
To
®
1970 - 001 - 10.10.2022