Table of Contents
Advertisement
During Use
During Installation
•
The operator panel is designed for stationary installation on a planar surface,
where the following conditions are fulfilled:
–
–
–
–
•
Install the operator panel according to the accompanying installation instructions.
•
Ground the operator panel according to the accompanying installation
instructions.
•
Only qualified personnel may install the operator panel.
•
Separate the high voltage, signal and supply cables.
•
Make sure that the voltage and polarity of the power source is correct before
connecting the operator panel to the power outlet.
•
Peripheral equipment must be appropriate for the application and location.
•
In a Zone 2 environment, this equipment shall be installed in an enclosure that
provides a degree of protection not less than IP 54 or greater than IP 65 in
accordance with IEC/EN 600079-0. The IP rating of the equipment is limited to
the IP rating of the enclosure it is to be installed into.
•
In a Zone 22 environment, this equipment shall be installed in an enclosure
that provides a degree of protection not less than IP 64 or greater than IP 65 in
accordance with IEC/EN 600079-0. The IP rating of the equipment is limited to
the IP rating of the enclosure it is to be installed into.
During Use
•
Keep the operator panel clean.
•
Emergency stop and other safety functions may not be controlled from the
operator panel.
•
Do not use excessive force or sharp objects when operating the touch screen.
14
no high explosive risks
no strong magnetic fields
no direct sunlight
no large, sudden temperature changes
Section 2 Safety Precautions
3BSE069462-600 Rev D
Advertisement
Table of Contents
