Preparation For Use - Sanyo MLS-3020U Instruction Manual

PREPARATION FOR USE

Installation
»Make sure to install the unit on a flat, sturdy surface floor.
Lock all four casters.
That the display indications will be difficult to read, if the unit
is located under direct sunlight.
•Avoid locations where the unit is exposed to air containing
large amounts of moisture, salt or sulfur, as these could ad-
versely affect the unit.
• The door opens out in a counterclockwise direction. Make
sure to allow sufficient clearance from impediments (walls,
posts, etc.) when positioning the unit.
•Allow at least 5 cm of free space between the back and left
sides of the unit and the nearest wall. Placing the unit too
close to the wall will cause heat to build up inside the unit
and that could cause the unit to malfunction.
Statement of the range of environmental conditions
• indoor use
• altitude up to 2000m
• temperature 5°C to 40°C
• maximum relative humidity 85%
• mains supply voltage fluctuations not to exceed + 10% of the nominal voltage
• transient overvoltages : installation categorie I
• polution degree 2
• do not exert vibration to the product.
15
At least 5 cm
*$* '///////;