Advertisement
Machine Translated by Google
Even if you insert a CD, "CD NO DISC" and "Can't READ" are
displayed. The playback sound is interrupted. ÿ Is the front and back
of the CD wrong? ÿ Is there any dirt or scratches? ÿ Are you using
a non-standard CD? ÿ Are you using it in an unstable place with a
lot of vibration? ÿ Is there a soup phenomenon? P.75 Even if I
press the operation button, it does not work. Also, it will stop in the
middle of the song and will not play correctly. ÿ Is the CD dirty or
scratched? ÿ Are you using a non-standard CD? ÿ Are you using it in
an unstable place with a lot of vibration? ÿ Is there a soup
CD
phenomenon? P.75 The playback sound is interrupted. ÿ Is the CD
dirty or scratched? ÿ Are you using it in an unstable place with a lot
of vibration? ÿ Is there a soup phenomenon? P.75
Continuous sounds such as "sea" and "za" are included
in the broadcast. ÿ Noise is generated when receiving a radio
broadcast near a TV, computer, word processor, etc. In such
cases, try moving away from areas where noise is likely to
occur. ÿ Is the direction of the antenna wrong? P.25 I can't
receive the radio broadcast well . There is a lot of noise.
a power
cord near the antenna wire, release it .
Please.
The registered broadcasting station cannot be called.
ÿ Did you unplug the power cord or have a power outage?
Please re-register. P.26
ÿ Did you perform the reset operation?
Please re-register. P.26
No disc
Cant lead
If there is
About the soup phenomenon
the following cases, soup (water droplets) may form on the internal lens
or disc. • Immediately after turning on the heating. • When placed in a
room filled with steam or humidity. • When you suddenly move from a cold
place (room) to a warm room. If it gets soaked ... The signal on the disc
may not be read and this product may not operate normally. To remove
the soup ... If you remove the disc and turn on the power, the soup will be
removed in about an hour and it will operate
normally.
If an abnormality occurs
While using this product, it may not be
displayed correctly if it receives strong external
noise (such as shock, excessive static electricity, or
abnormal power supply voltage due to a lightning
strike) or if an incorrect operation is
as not being able to accept operations. In such a case, perform the reset
operation as follows. Reset operation
1 Power cord
2 Hold down [POWER]
Unplug from
Plug in the power cord.
the outlet.
The power turns off after "RESET" is
displayed for about 1 second.
Note If
you perform the reset operation, all the registered contents will be deleted.
1-BIT MD / CD SYSTEM SD-FX10
In
performed.
An error may occur, such
reset
"
Is it
a
hindrance?
"
If
you think
Consideration
75
Advertisement
