At#Trace - Enable/Disable Trace - Telit Wireless Solutions LE910C Series At Commands Reference Manual

LE910Cx AT Commands Reference Guide

3.2.2.46. AT#TRACE - Enable/Disable Trace

The command selects which trace outputs you want to display through the debugging
tool.
SIM Presence Setting saved
Not required
AT#TRACE=[<mode>[,<configurationString>]]
Parameters:
Name
<mode>
<configurationString>
Additional info:
The syntax of the <configurationString> is:
["<unit>=<umode>[,<unit>=<umode>[,...]]"]
Here are the meanings and values of the string parameters.
80502ST10950A Rev. 14
Can be aborted
No No
Type Default
integer N/A
Values:
0 : sets all trace outputs OFF,
<configuration String> will be ignored
1 : sets all trace outputs ON,
<configurationString> will be ignored
string
Page 184 of 1904
Not Subject to NDA
MAX timeout
-
Description
switches all trace outputs ON
or OFF. If parameter <mode>
is no entered in
the command, the following
<configurationString> will be
used.
- enables/disables a set of
trace outputs, its syntax is
shown in the Additional info
section.
SELINT
2
2022-03-04