Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DeWalt XR LI-ION DCD999X1
Summary of Contents for DeWalt XR LI-ION DCD999X1
- Page 1 DCD999...
- Page 2 English (original instructions) Copyright D WALT...
- Page 3 Fig. A Fig. B XXXX XX XX...
- Page 4 Fig. C Fig. D Fig. E...
-
Page 5: Technical Data
English IMPACT DRILL DCD999 Congratulations! The vibration and/or noise emission level given in this information sheet has been measured in accordance with a standardised test You have chosen a D WALT tool. Years of experience, thorough given in EN60745 and may be used to compare one tool with product development and innovation make D WALT one of the another. -
Page 6: Work Area Safety
English Batteries Chargers/Charge Times (Minutes) Weight (kg) DCB104 DCB107 DCB112 DCB113 DCB115 DCB116 DCB117 DCB118 DCB132 DCB119 Cat # DCB546 18/54 6.0/2.0 1.05 DCB547 18/54 9.0/3.0 1.46 135* 110* 135* DCB181 0.35 DCB182 0.61 60/40** 60/45** 60/40** 60/40** DCB183/B 0.40 DCB184/B 0.62 75/50**... - Page 7 English 5) Battery Tool Use and Care d ) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached a ) Recharge only with the charger specified by the to a rotating part of the power tool may result in manufacturer.
-
Page 8: Residual Risks
English Safety Instructions When Using Long Mains Plug Replacement (U.K. & Ireland Only) Drill Bits If a new mains plug needs to be fitted: • Never operate at higher speed than the maximum • Safely dispose of the old plug. speed rating of the drill bit. At higher speeds, the bit is likely •... -
Page 9: Charger Operation
English Charger Operation • Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug Refer to the indicators below for the charge status of the and cord. battery pack. • Make sure that cord is located so that it will not be Charge Indicators stepped on, tripped over, or otherwise subjected to damage or stress. -
Page 10: Charger Cleaning Instructions
English exposed. Align the slots on the back of the charger with the damaged in any way (i.e., pierced with a nail, hit with exposed screws and fully engage them in the slots. a hammer, stepped on). Electric shock or electrocution may result. -
Page 11: Storage Recommendations
English Transporting the FlEXVOlT Battery Have defective cords replaced immediately The D WALT FLEXVOLT battery has two modes: Use and Transport. Use Mode: When the FLEXVOLT battery stands alone or is in Charge only between 4 ˚C and 40 ˚C. WALT 18V product, it will operate as an 18V battery. When the FLEXVOLT battery is in a 54V or a 108V (two 54V batteries) Only for indoor use. -
Page 12: Description (Fig. A)
English Markings on Tool ASSEMBLY AND ADJUSTMENTS The following pictograms are shown on the tool: WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect battery pack Read instruction manual before use. before making any adjustments or removing/ installing attachments or accessories. - Page 13 English Three‑Speed Gearing (Fig. A) accommodate left‑ or right‑ handed users. If the hook or magnetic bit holder is not desired at all, it can be removed from The three‑speed feature of your tool allows you to shift gears the tool. for greater versatility.
- Page 14 English switch and remove the battery from the tool when fastener at the desired depth. The lower the number, the lower the torque output. changing acces sories. 2. Reset the torque adjustment collar to the appropriate WARNING: Always ensure the bit is secure before starting 5 ...
-
Page 15: Protecting The Environment
English MAINTENANCE Rechargeable Battery Pack Your power tool has been designed to operate over a long This long life battery pack must be recharged when it fails period of time with a minimum of maintenance. Continuous to produce sufficient power on jobs which were easily done satisfactory operation depends upon proper tool care and before. - Page 16 Belgique et WALT - Belgium BVBA Tel: NL 32 15 47 37 63 www.dewalt.be Luxembourg België en Luxemburg Egide Walschaertsstraat 16 Tel: FR 32 15 47 37 64 enduser.BE@SBDinc.com 2800 Mechelen Fax: 32 15 47 37 99 Danmark WALT (Stanley Black&Decker AS)