English IMPACT DRILL DCD999 Congratulations! DCD999 You have chosen a D WALT tool. Years of experience, thorough DCB184 DCB546 DCB547 product development and innovation make D WALT one of the Power 1219 1296 most reliable partners for professional power tool users.
Impact Drill WARNING: Indicates a potentially hazardous situation DCD999 which, if not avoided, could result in death or serious injury. WALT declares that these products described under Technical Data are in compliance with:...
English h ) Do not let familiarity gained from frequent use of 2) Electrical Safety tools allow you to become complacent and ignore a ) Power tool plugs must match the outlet. Never tool safety principles. A careless action can cause severe modify the plug in any way.
English Safety Instructions When Using Long contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns. Drill Bits e ) Do not use a battery pack or tool that is damaged or Never operate at higher speed than the maximum modified.
English Do not operate charger if it has received a sharp blow, minimum conductor size is 1 mm ; the maximum length • been dropped, or otherwise damaged in any way. Take it is 30 m. to an authorised service centre. When using a cable reel, always unwind the cable completely. Do not disassemble charger;...
English hot/Cold Pack Delay Do not charge or use battery in explosive atmospheres, • such as in the presence of flammable liquids, gases or When the charger detects a battery pack that is too hot or too dust. Inserting or removing the battery from the charger may cold, it automatically starts a Hot/Cold Pack Delay, suspending ignite the dust or fumes.
Page 11
English materials that could contact them and cause a short 3 batteries of 36 Wh each. The Use Wh rating might indicate circuit. NOTE: Lithium‑ion batteries should not be put in 108 Wh (1 battery implied). checked baggage. Storage Recommendations WALT batteries comply with all applicable shipping 1.
English Battery Type Chuck sleeve Speed selector The following tools operate on a 18 volt battery pack: DCD999 . Worklight These battery packs may be used: DCB181, DCB182, DCB183, DCB183B, DCB183G, DCB184, DCB184B, DCB184G, DCB185, Worklight switch DCB187, DCB189DCB546, DCB547. Refer to Technical Data for Belt hook (Optional accessory) more information.
Page 13
English To actuate the fuel gauge, press and hold the fuel gauge If model is not equipped with side handle, grip drill with one 17 button . A combination of the three green LED lights will hand on the handle and one hand on the battery pack. illuminate designating the level of charge left.
English OPERATION Spotlight Mode The high setting is the spotlight mode. The spotlight will run Instructions for Use for 20 minutes after the trigger switch is released. Two minutes WARNING: Always observe the safety instructions and before the spotlight will shut off, it will flash twice and then dim. To avoid the spotlight shutting off, lightly tap the trigger switch.
English 4. Hold tool firmly with both hands to control the twisting Use a cloth dampened only with water and mild soap. action of the drill. Never let any liquid get inside the tool; never immerse any 5. iF DRill sTAlls, it is usually because it is being part of the tool into a liquid.
Page 16
Belgique et WALT - Belgium BVBA Tel: NL 32 15 47 37 63 www.dewalt.be Luxembourg België en Luxemburg Egide Walschaertsstraat 16 Tel: FR 32 15 47 37 64 enduser.BE@SBDinc.com 2800 Mechelen Fax: 32 15 47 37 99 Danmark WALT (Stanley Black&Decker AS)
Page 21
English BRUSHLESS CORDLESS COMPACT IMPACT DRIVER DCF850 Congratulations! hands warm (relevant for vibration), organisation of You have chosen a D WALT tool. Years of experience, thorough work patterns. product development and innovation make D WALT one of the most reliable partners for professional power tool users. EC-Declaration of Conformity Technical Data Machinery Directive...
Page 23
English c ) Do not expose power tools to rain or wet conditions. b ) Do not use the power tool if the switch does not turn Water entering a power tool will increase the risk of it on and off. Any power tool that cannot be controlled electric shock.
Page 24
English g ) Follow all charging instructions and do not charge Follow the fitting instructions supplied with good quality plugs. the battery pack or tool outside the temperature Recommended fuse: 3 A. range specified in the instructions. Charging Using an Extension Cable improperly or at temperatures outside the specified range An extension cord should not be used unless absolutely may damage the battery and increase the risk of fire.
English * The red light will continue to blink, but a yellow indicator light Place the charger in a position away from any heat source. The will be illuminated during this operation. Once the battery pack charger is ventilated through slots in the top and the bottom has reached an appropriate temperature, the yellow light will of the housing.
English Battery Packs CAUTION: When not in use, place tool on its side on a stable surface where it will not cause a tripping Important Safety Instructions for All or falling hazard. Some tools with large battery packs Battery Packs will stand upright on the battery pack but may be easily When ordering replacement battery packs, be sure to include knocked over.
English resulting in 3 batteries with a lower Watt hour (Wh) rating as Charge D WALT battery packs only with designated compared to 1 battery with a higher Watt hour rating. This WALT chargers. Charging battery packs other increased quantity of 3 batteries with the lower Watt hour rating than the designated D WALT batteries with a can exempt the pack from certain shipping regulations that are...
Page 28
English Date Code Position (Fig. B) 2. Insert battery pack into the charger as described in the charger section of this manual. The production date code 14 consists of a 4-digit year followed by a 2-digit week and is extended by a 2-digit factory code. Fuel Gauge Battery Packs (Fig.
Page 29
English Proper hand position requires one hand on the main DCF850 handle 10 Mode 1 Precision Drive 0–1000 Variable Speed Trigger Switch (Fig. A) Mode 2 Normal Impacting 0–2800 To turn the tool on, squeeze the trigger switch 1 . To turn the Mode 3 High Speed Impacting 0–3250...
Page 30
English WARNING: To reduce the risk of serious personal • Run the battery pack down completely, then remove it from injury, turn tool off and disconnect battery pack the tool. before making any adjustments or removing/ • Li-Ion cells are recyclable. Take them to your dealer or a installing attachments or accessories.
Page 32
Belgique et www.dewalt.be WALT - Belgium BVBA Tel: NL 32 15 47 37 63 luxembourg België en luxemburg Egide Walschaertsstraat 16 Tel: FR 32 15 47 37 64 enduser.BE@sBDinc.com 2800 Mechelen Fax: 32 15 47 37 99 Danmark WALT (Stanley Black&Decker AS)