Ist 008 Installing Frame Grabber Board - GE Centricity RA600 Service Manual

Hardware Installation
n

IST 008 Installing Frame Grabber Board

Section 1: Introduction
This job card describes how to install the a frame grabber board into the Centricity RA600
Workstation.
Section 2: Tools Required
u
5 mm cross-head screwdriver
u
5 mm flat-head screwdriver
u
Grounding wristband
Section 3: Procedure
Caution
!
1. Power off the system.
2. Remove the left-hand half of the Dell 1400 computer case.
l
Slide the rear padlock hasp toward the chassis center and press the release button on the
lower front of the bezel and remove the left side of the case.
l
For detailed instructions, refer to the Dell Online Documentation, Dell PowerEdge System
Documentation, Dell PowerEdge 1400, PowerEdge 1400 Installation and Troubleshooting
The components inside the workstation computer case may be
damaged by static electricity. Observe standard grounding
precautions for handling static-sensitive components when
performing this procedure.
Page 55
IST 008 Installing Frame Grabber Board