Track Removal And Installation; Track Removal - ASV RC30 Service & Repair Manual

Rubber Track Loader
12. Undercarriage Disassembly and Assembly
Figure 12-21
2. Insert and tighten the two bolts that fasten the
brake cylinder to the rail.
3. Replace the outside wheel directly behind the
drive sprocket. Refer to Chapter 12. Wheel In-
stallation.
Track Removal and
Installation
The tools required for track removal and installation
are listed in Table 12-4. Use manufacturer-
recommended tools whenever possible.
Table 12-4
Required Tools
Socket Wrench
Combination Wrench
Crowbar

Track Removal

! WARNING !
To remove the tracks, the machine must be jacked up and
placed on jack stands sturdy enough to support the weight
of the machine. The manufacturer-supplied jack stands
are recommended.
12-021
Floor Jack
Straight Edge
Tape Measure
https://www.tractormanualpdf.info/
Figure 12-22
1. Locate the wheels marked A and B. If the track
is to be removed, these wheels and the wheel to
the inside of B must also be removed.
Figure 12-23
2. Remove the wheels located in step 1. Refer to
Chapter 12. Wheel Removal.
Figure 12-24
3. Loosen the jam nut located on the track ten-
sioner. A field wrench located under the right
fender of the machine can be used, but a stan-
dard wrench is preferred for shop use.
12-6
12-004
12-016
12-011