Beats Solo3 Wireless Manual

CONNECTING TO iPHONE WITH iOS 10

To connect to iPhone with iOS 10 or later follow steps 1–3. For all other devices see the back of this guide.

TURN ON BLUETOOTH

Swipe up from the bottom of the screen and tap the Bluetooth^® icon.

CONNECT SOLO³ WIRELESS

Press power button for 1 second. Hold near unlocked iPhone, then follow onscreen instructions.

START LISTENING

Your Solo 3 Wireless is now connected and ready to use.

USE WITH YOUR OTHER APPLE DEVICES

Solo³ Wireless now works with your other devices signed into iCloud. Select Beats Solo³ in Control Center (iOS) or menu bar (macOS).

WIRELESS CONTROLS

During wireless use, control music and manage calls with the "b" button. Adjust volume above and below the "b" button.

WIRELESS SETUP FOR OTHER DEVICES^*

Press power button for 5 seconds. On your device, go to Bluetooth^® settings and choose Beats Solo³.

* iOS 9 or earlier, Android^TM and other Bluetooth^® enabled devices.

WIRED PLAYBACK

Plug in RemoteTalk cable for wired mode to conserve battery or when battery is depleted.

WIRED CONTROLS

* Functionality may vary on non-Apple devices.

CHARGE

Using a micro USB cable, plug in headphones to charge.

	Fuel gauge = battery status
	Charged
	Charging

beatsbydre

@beatsbydre

beatsbydre

@beatsbydre

© 2016 Apple Inc. All rights reserved. Model: A1796. PA034-01424.

The b logo, beats, beats solo, remotetalk and solo are trademarks of Beats Electronics, LLC. Apple, iPhone, macOS and watchOS are trademarks of Apple Inc., registered in the U.S. and other countries. Android is a trademark of Google Inc. The Bluetooth^® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and are used under license. IOS is a trademark of Cisco and is used under license.