Beats Studio 3 Wireless Manual

TURN ON BLUETOOTH

Swipe up from the bottom of the screen and tap the Bluetooth icon or enable Bluetooth via Siri.

CONNECT BEATS STUDIO 3 WIRELESS

Press power button for 1 second. Hold near unlocked iPhone, then follow onscreen instructions.

START LISTENING

Your Beats Studio 3 Wireless is now connected and ready to use.

WIRELESS CONTROLS

During wireless use, control music and manage calls with "b" button and adjust volume above or below. Hold "b" button to activate Siri or voice command*.

* Functionality may vary on non-Apple devices.

PURE ADAPTIVE NOISE CANCELING (PURE ANC)

Pure ANC is enabled each time you power on Beats Studio 3 Wireless, reducing external noise during playback.

SWITCHING BETWEEN PURE ANC ON AND OFF

To switch Pure ANC off for low power mode, double-press the power button while connected to your device. To turn Pure ANC back on, repeat this process.

WIRED PLAYBACK

Plug in the included RemoteTalk cable for wired mode.

REMOTETALK CONTROLS

Control music, manage calls, activate Siri or voice command, and adjust volume with RemoteTalk cable*.

* Functionality may vary on non-Apple devices.

CHARGE AND BATTERY STATUS

Plug in a micro USB cable to charge headphones.

	Charged
	Charging
	Low Battery

beatsbydre
@beatsbydre
beatsbydre
@beatsbydre

© 2017 Apple Inc. All rights reserved. Model: A1914. 034-02094-A.

The b logo, beats, beats studio, and remotetalk are trademarks of Beats Electronics, LLC. Apple, iCloud, iPhone, macOS, Siri, and watchOS are trademarks of Apple Inc., registered in the U.S. and other countries. Android is a trademark of Google Inc. The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Apple is under license. iOS is a trademark or registered trademark of Cisco in the U.S. and other countries and is used under license.