Shark UV700 Quick Start Guide

Please be sure to read the enclosed Shark^® Owner's Guide prior to using your unit.

Use this Quick Start Guide to learn about your new vacuum's great features.

UPRIGHT

Power
Press the Power/Surface Selector button to turn the vacuum on or off.

Floor Setting
Slide the Power/Surface Selector button up or down to choose floor type.

LIFT-AWAY

MAINTENANCE

Zero-M™ Technology

Zero-M Technology™ actively removes hair wrap from your brushroll while you vacuum. If you run over a hard or sharp object or notice a noise change while vacuuming, check for blockages or objects caught in the brushroll.

CLEANING THE BRUSHROLL

To open the brushroll garage, slide both release buttons on the floor nozzle away from you, towards the back of the nozzle, then lift off the lid. Clear away any objects or debris.

To close the brushroll garage, insert the 3 tabs on top of lid into the 3 slots in the nozzle, then push down on both sides of lid until it clicks securely into place.

NOTE: If any hair is wrapped around the brushroll, extending cleaning time will allow Zero-M™ technology to remove it for you. If some fibers remain wrapped around brushroll after continued use, carefully cut debris with scissors and remove from brushroll.

CLEANING THE SOFT ROLLER

To remove the Soft Roller from the nozzle, lift it out by the pull tab. Tap loose debris off the Soft Roller. Use a dry towel to wipe the Soft Roller clean, or to remove any debris caught in the teeth behind the Soft Roller.

Hand wash the Soft Roller as needed. Use only water, and let air-dry completely for at least 24 hours. Reinsert the Soft Roller under the rubber bumper in the front of the nozzle until it clicks into place.

To register your product, or for answers to frequently asked questions, visit registeryourshark.com.

©2018 SharkNinja Operating LLC. SHARK is a registered trademark of SharkNinja Operating LLC.