Advertisement
Remove the System control board/Card
wire sub board
Prior to performing the following procedure, remove
the top cover, the HDD board assembly and the rear
cover.
1.
Remove the screw H attaching the card wire sub
board on the left side of the body (The card wire sub
board can be removed if only the top cover has been
removed).
2.
Disconnect the card wire from connector CN602 and
CN605 on the system control board.
3.
Remove the three screws I .
4.
Disconnect the connector CN603 and CN604
outward and remove the system control board.
5.
Disconnect the wire from connector CN501 on the
inside of the system control board.
Removing the Card wire sub board/
Headphone board/ Heat sink
Prior to performing the following procedure, remove
the top cover, the HDD board assembly and the rear
cover.
1.
Remove the screw J on the right side of the body
(The card wire sub board can be removed if only the
top cover has been removed).
2.
Disconnect the card wire from connector CN661 and
CN695 on the main amplifier board.
(See Fig.13,14)
System control board
(See Fig.15~18)
System control board
CN602 CN605
Card wire sub board
Fig.13
CN603
I
CN501
Fig.14
CN695
CN661
Fig.15
NX-HD10
Front panel
H
I
I
CN604
amplifier board
Main
Card wire sub board
J
1-9
Advertisement
