Advertisement
Removing the Regulator board
Prior to performing the following procedure, remove
the top cover, the HDD board assembly, the rear
cover, the system control board and the main
amplifier board.
1.
Disconnect the wire from connector CN903 and
CN955 on the back of the body.
2.
Remove the four screws P attaching the regulator
board.
Removing the Fan assembly (See Fig.21)
Prior to performing the following procedure, remove
the top cover, the HDD board assembly, the rear
cover, the system control board, the main amplifier
board and the regulator board.
1.
Remove the band setting the fan assembly wire on
the back of the body.
2.
Loosen the screw Q and remove the screw R
attaching the fan assembly.
Removing
the
assembly
Prior to performing the following procedure, remove
the top cover, the HDD board assembly, the rear
cover, the system control board, the main amplifier
board and the regulator board.
1.
Remove the four screws S
assembly attaching bracket and the silicon steel
plate. Release the two joints
remove the fan assembly attaching bracket (The fan
assembly will comes off at the same time).
Joint d
Fig.21-3
(See Fig.20)
Power
transformer
(See Fig.21~23)
attaching the fan
d
backward and
Joint d
Fig.21-2
Regulator board
Fan assembly
Q
attaching bracket
Power transformer
Silicon steel plate
Fan assembly
attaching bracket
S
NX-HD10
P
P
CN903
CN995
P
P
Fig.20
Fan assembly
Band
Fig.21
Joint d
Fig.21-1
R
S
1-11
Advertisement
